0 Members and 8 Guests are viewing this topic.
You could at least smile for us TRN Raising boys into RealMen!!
no not yet. Its just a matter of time. hes been very elusive. Confession of a tech saavy redneck....I have a security camera on the feeder and I can lay in bed and watch it at night. Then I can open the living room window and use the end table as a shooting bench to wack him. just a matter of time.
You need a claymore array under the feeder - click, click and you're BBQing!
So, Bobby...being the calculating trained warrior NCO that you are. Take the appropriate action, Execute!
your standard grunt level CQB is just putting rounds and rounds on scary stuff till it stops scaring you!
He was back at 3 amSent from my iPhone using Tapatalk
Wonder if this would be a good enough excuse for a PVS22? A magnified image would be nice. Or maybe I'll just duct tape the pvs14 to the front of my 3-9 on my titanium hunting rifle.
Thanks Bobby. If I get a pvs22/27 I'll have to install that on one or more of the precision rifles. JR that's the set up I have now except it's the ITT Pinnacle GenIII PartOne of problem is the mount I'm using. It's perfectly co witnessed with my Comp M4 set up on the SBR but the mount on the AR with the Comp M2 is a bit higher so it's hard to get a good picture through it. Sent from my iPhone using Tapatalk
Minot familiar with that Bobby. Break it down for me. Sent from my iPhone using Tapatalk
Will have to look this weekend. I bought it used with the mount. Yes, it sits about 1/4 inch high