0 Members and 4 Guests are viewing this topic.
Capping the mounts will look good and the gusset will help for sure.As for the upper tube, I'm sure you will think of something.How are you going to grind all that covered up?
Hey Norm, where have you been? It's almost June...!
Quote from: Flyin6 on May 30, 2015, 08:57:49 PMHey Norm, where have you been? It's almost June...!I'll bet he's watching Mrs. Norm work really hard on that project!
I'm liking the front bumper, kinda what I have in mine for mine but less plate. How about a tube from the main top hoop to the lower one that goes around to the side fender to protect the front corner of the front fender? Does that make sense?
Looks good Don. I like the horizontal you added. It looks better than what I drew, for sure. Any idea of the total weight so far?
The square tube support with it tying into the push tube looks great.Just don't stop fast, I think you may roll onto the front axle!
Quote from: JR on June 02, 2015, 01:01:59 AMThe square tube support with it tying into the push tube looks great.Just don't stop fast, I think you may roll onto the front axle!Counterweight my friendThe thing I'm building on the back end will make this look like an erector set!It'll balance. But when I come to a stop in hot asphalt, the truck might just sink!
I just don't want to wind up missing a digit or limb. I can sometimes get in a hurry to get results.
Looking good Don, and just wow at the welding/grinding on that thing. Where will you mount the license plate?
Looking good.