So not much progress on anything that interests me outside of normal work lately. However, I haven’t been slacking. I’ve been completing legit “honey” do’s along with cleaning up chicken doo.

So the wife’s bees and chicks have taken a priority as of late. I have a rubber maid water trough with 13 chicks in it residing in my machine shop and they’re dirty. We purchased this bare coop a couple months ago. I had to get power to it, then wire, insulate and sheet it. I stated by using 1” foam board on the floor covered by treated plywood and then linoleum. Walls / ceiling received r13, then was topped with osb and outdoor receptacles. I ran power off an external gfi receptacle from the big shop.

We still need to build the run and finish wiring the auto dawn to dusk chicken door yet.

Honey bee’s are doing well and she already installed the next section above for them to start filling. We’ve had them around 11 days thus far. Fairly large learning curve those bees have been.


Sent from my iPhone using Tapatalk

You guys are fun, 

It wasn't missing. Someone knew where it was.

True...But just not the right person to prevent the inevitable statement of charges!

One possibility for the gen set is a front mount for the truck. Maybe a receiver and hitch hauler kind of set up.

Thought about that
But
I don't like the idea much. From what I've seen of these setups, the truck gets long, and if you bump anything up front, well...

I have a "Fat lower lip bumper and rear step for the camper. There's enough room for a modest box there.

Thanks.  He really wanted to stay in the trade.