Hello Guest

Recent Posts

Pages: [1] 2 3 ... 10
1
Build Threads / Re: 2002 Suburban 2500 build thread, Part 2
« Last post by TexasRedNeck on January 22, 2019, 10:17:35 PM »
So I guess that means no stroker kit?


Sent from my iPad using Tapatalk
2
D.O.T. / Re: WDYDT (What Did You Do Today)
« Last post by KensAuto on January 22, 2019, 09:55:32 PM »
Finally moving this termite and bee infested service pole out of the middle of my driveway at work. Hard to tell but it's leaning towards the camera quite a bit. Previous owners had placed a pole about 50 feet away but still 100 feet from the shop. I dug it up and moved it straight across from the panel in the shop.
It's not very straight but at least it's not rotten.
3
Build Threads / Re: 2002 Suburban 2500 build thread, Part 2
« Last post by Flyin6 on January 22, 2019, 09:48:33 PM »
And that is the enchilada for today, get back at it in the morn.
4
Build Threads / Re: 2002 Suburban 2500 build thread, Part 2
« Last post by Flyin6 on January 22, 2019, 09:47:26 PM »
Then torqued the oil pan down
5
Build Threads / Re: 2002 Suburban 2500 build thread, Part 2
« Last post by Flyin6 on January 22, 2019, 09:46:32 PM »
Felpro supplied the oil pan gasket. I applied four small dabs of RTV to the parting lines of the front and back covers where they mate to the oil pan
6
Build Threads / Re: 3+3 2500
« Last post by JR on January 22, 2019, 09:42:45 PM »
Nice work so far. Are you going with the spring caps or preload?
7
Build Threads / Re: 2002 Suburban 2500 build thread, Part 2
« Last post by Flyin6 on January 22, 2019, 08:51:27 PM »
Bolting stuff back on...good feeling to reverse the trend line!
8
Build Threads / Re: 2002 Suburban 2500 build thread, Part 2
« Last post by Flyin6 on January 22, 2019, 08:49:03 PM »
It's a 6.0L for sure!

Next up the cam/timing cover. Bolts loose for now, snugged after the oil pan install
9
Build Threads / Re: 2002 Suburban 2500 build thread, Part 2
« Last post by Flyin6 on January 22, 2019, 08:46:42 PM »
Used some stickems to hold down the harness, then applied a 1/4" tall dam of RTV as per the GM bulletin that Ken also supplied. So, thanks to him, I think the job is done right.
10
Build Threads / Re: 2002 Suburban 2500 build thread, Part 2
« Last post by Flyin6 on January 22, 2019, 08:45:06 PM »
New wiring harness as per Ken's recommendation
Pages: [1] 2 3 ... 10