Have any of you guys dealt with the "active" suspension system on these things? I'm having trouble finding much good information about how to deactivate this system without having the suspension message in the dic.
This truck has had a lift kit on it since before I got it, and as far as I know, the message has been on since the lift kit was installed.
There's a bit of info out there about using resistors in place of the shocks. I ordered some of the resistors, but my truck doesn't seem to match the info that's out there.
The stuff I've read all said that the connectors at the shocks had 2 wires in them and to just stick the resistors between the two wires. On my truck, the only connectors Iwas able to find near the shocks have 3 wires. The Chilton manual I have is about useless in the wiring schematic department, so I wasn't able to figure it out that way either.
Hopefully I'm just not finding the correct connectors, and I plan to look again, but I figured I'd ask the pros here as well.
Thanks for all the help!