1
Build Threads / Re: Don's 2024 Ram 3500
« Last post by Flyin6 on Today at 06:47:53 PM »I began the chore day by reinstalling the rear wheel well liners
They are pretty big, but unlike the GM units, these are a lot thinner and floppier. I trimmed four big inside flaps away that were obscuring the part of the overload spring that I like to view to see if they are in contact with my revised pads. Once I did that the liners were easier to handle.
Oh, and the airbags are holding air just fine now. It was the Pac-Air flexible inlet fittings that were the culprit.
They are pretty big, but unlike the GM units, these are a lot thinner and floppier. I trimmed four big inside flaps away that were obscuring the part of the overload spring that I like to view to see if they are in contact with my revised pads. Once I did that the liners were easier to handle.
Oh, and the airbags are holding air just fine now. It was the Pac-Air flexible inlet fittings that were the culprit.