VEHICLES, CAMPERS, and BOATS > General Maintenance, How to/DIY projects
New Mouse Trap Design
Flyin6:
I didn't say, "A better mousetrap, just a different one
Starts with two standard 5 gal buckets
Flyin6:
And a piece of 1/4" steel to act as an axle
Flyin6:
I drilled holes just above the handle holes
Flyin6:
Then cut two sections of conduit PVC tubing that spanned the space minus about 1/4" and drilled a hole in the center of that
Flyin6:
Then comes two more holes about 1/2"-3/4" outboard from the center hole.
Through those holes, I placed two 5/16" bolts capped with nyloc nuts and adjusted same until I was left with something that would return to "about-level" when disturbed.
Navigation
[0] Message Index
[#] Next page
Go to full version