Yep, you guessed it. Super careful, don't want to start over again.

OK, here are 2 more pics. Sure it gives it away;

rafter anchor.

close, but something sits on it that needs to move a little.

I had some pics I need to reload them, not hinges, look up.

48 volt is the way to go from what I read. I found the guys on a couple forums to be jerks and stopped asking questions.

GC batteries are great and you can change out bad ones easy, but you need about 50 to match a lift battery.

For something totally off grid I would look at lift batteries, for a weekend here and there GC would be fine. However getting a lift battery to some places my present a challenge since you cant just cart em in.

My second solar system (DIY) has a stand alone 1500watt outlet for when the grid is down. Won't save the world but will run the fridge and charge a few batteries.

I still think for long term the forklift battery is what to look for. Sure about $1000 but a 20+ year life and all the power you ever need.

https://youtu.be/2NPPE6a7mSI

Post those specs please for the front and rear. I am doing both mine soon (4.56)

They are both neglected and dusty,,,,,,,,,,,,,,

Here is what it looks like now, just needs a little mud. The 2 upper panels are temp to block the roof/insulation/air issues.

Can someone guess what these are??

Looks a little better with sheetrock. I did have a little help pulling wires since getting in there is not fun for me. My youngest fits fine.

Well, onto other things.

Stairs are going great, check the thread.

Got these, both work great;

So I see now that I found thread #2. Still catching up.

Trying to catch up this Don, just on page 2.

Why would the Orion come up on this?

He is a wild card. That may be all that gets us by here.

I hear to many people who say they cannot vote for H, no matter what. The poles are twisted too, they even say they poll more D because there are more, really? I think if you add the independents in with the Rs it is a tossup.

I also think many who are for Trump are afraid to say it. Look at the poor guy in So Cal who had to be saved by the cops.

I fear if she gets in, she gets 3 justices and they say we may loose the senate to boot.

You need to look at the cognito steering items. The HD tie rods are junk but the pitman arm and the cross link have great upgrades.

I would do the CP3 myself. When I did the fittings it was not that hard once you slide it all off the top. Sure I didn't do my CP3, but I was right there.

Try youtube. At least you get pictures.

I used the cheap HF pullers, they worked fine. Heat helps as the arm is going in the garbage anyway.

Still bet you were smiling big,,,,,,,,,,,,,,,,,,,,,,

Just $120 huh? Mine is flattened on the bottom from sitting there. Think they would have used wood to the block base, it is so easy!!

I too like getting ALL the oil out, that sounds like a plan.

I love the stack and you were smiling more than the kid. Wait, you are the kid!!

Could you get a feeler gauge between the rods?

Maybe send out the oil to see what it really is??

I was thinking like an old locomotive where they got out to fill the oil reservoirs.

Drill it and put a grease fitting in there, done.

You sure it didn't drip from somewhere else?

They are a little cheaper on ebay plus you get battery backup!

We can talk about SD anywhere, no rules!

Something is fishy there for sure. Ask your mech if the seal he pulled has a part# on it. See how custom it really is for $85 !!!!!

From what you say it is not his fault unless you pay him big bucks. Buying it though may have included a disclaimer, but you still have the forums and Paypal. Sure you still a have a few contacts too.