0 Members and 4 Guests are viewing this topic.
I just don't want to wind up missing a digit or limb. I can sometimes get in a hurry to get results.
Fighting with blower motor in truck. Ken any ideas?Digital dual climate. PWM fan controls. New fan now...Have power at all HVAC fuses. Have power at input to PWM, have variable resistance to control output. Have 7-12 volts output from PWM controller to fan plug. Add solid ground to fan plug negative and goes to beat all. Old fan no go, new fan no go. Old fan goes now with lighter plug and inline fuse. Bad ground?Bad ignition switch switch?Bad PWM controller?Somewhere something not giving power. Anybody else seen this?2006 LBZ loaded at the time.
Changed the oil and fuel filters on the Dmax today. Found my lift pump is not lifting (no power) and all the fuses are good. I mean they are ALL good, inside and out!Traced the power wire to the distribution center under the dash where I had installed a plug just to power things. The red wire is "ign on" power and worked fine, now nothing. It powered the water inj also so that is why that stopped too. The cut and the yellow wire were for the injection, just removed the splice.So I am stumped as with no fuses being bad and everything otherwise working (sans dash lights). I could just wire it to another pin (green arrow) but would like to address the issue really.Put a 1 way fuel valve in the suburban. Always hard to start with pump up top figuring the fuel is draining back. Quick fix until the lift and new filter goes in.
Sam, Tate referenced the conversion replacement. I think Delco is the only one to offer a direct bolt-in iirc.The second one is delco
Gave the sissy truck its biggest work out yetAbout 9200 lbs. I was surprised how well and drama free it pulled it. Not as stable as the dually but not bad at all. Sent from my iPhone using Tapatalk
the bacon is resting in the fridge till tomorrow when it will receive smoke and heat...
This cold weather up here and all the rain JR isn’t soaking up is causing lots of havoc at the job site, mostly me with cold wet feet!! So I ordered me a upgraded Boot dryer and received yesterday Sent from my iPhone using Tapatalk
Quote from: Nate on November 29, 2018, 01:25:54 PMthe bacon is resting in the fridge till tomorrow when it will receive smoke and heat... You ever try making beef bacon? I have some beef belly in the freezer waiting for me to. Supposedly you make it the same as pork.
You need a set of rocky boots.....
Quote from: stlaser on November 30, 2018, 10:29:12 AMYou need a set of rocky boots.....I have Owned one pair of Rocky’s and I will never again, worst boot I have ever purchased, soul is terrible on cold weather, they are heavy and not any more or less waterproof than the USA Made thorogood boots. Still have them in the closet for a oh crap use but. I didn’t like them at all Sent from my iPhone using Tapatalk
Cheese is finished
Quote from: Farmer Jon on November 30, 2018, 07:37:46 AMQuote from: Nate on November 29, 2018, 01:25:54 PMthe bacon is resting in the fridge till tomorrow when it will receive smoke and heat... You ever try making beef bacon? I have some beef belly in the freezer waiting for me to. Supposedly you make it the same as pork. Jon, heres what i was told about beef bacon."Nate, Yes, I make beef bacon. The most commonly used cut is the naval plates, a cut from the belly. Purchase with the skin removed, cure as if it were pork belly.The fat of the naval plate is important for the flavor and for frying, just don't fry until crispy, leave flexible. Great flavor.Bob"
Sounds like a lot of fun. Problem is when I go to events like that I spent way too much at the snack bar. Just can't say no to the nachos and hot dogs!We got a few inches of snow. Its heavy wet stuff. Not too cold out. In the teens. It's just a pain. Makes everything not work right feeding cattle and getting stuck in it. The snow plow went by at least. Now it's still coming down slowly and blowing. Sent from my Pixel 2 XL using Tapatalk