VEHICLES, CAMPERS, and BOATS > Powerplant, Driveline, and Braking

Ball Joint recommendations

(1/7) > >>

cj7ox:
So, at about 330k miles, the ball joints on my 2006 Ram 3500 (4WD, SRW) are in need of replacement. I'm trying to figure out what the best route, parts wise, is for the next 300k. I've looked at MOOG, but understand there may be some quality issues recently. So, I've decided to leverage the collective wisdom of this group. What say you?

stlaser:
Hit up Phil or look at his Dodge Cummins build thread.

Flyin6:
I use Moog in my 2500 Chevy, but, I concur with Shawn's recommendation

Dodges seem to be particuliar in what they like...

KensAuto:
I've switched from Moog to Mevotech and so far so good.
Now if you wanna go all in, there's the guys that make extreme duty joints specifically for Rams, but a little pricey.
...I think the ones Shawn's referring to that Phil uses.

cj7ox:
Yeah, I was leaning toward Moog. It's just hard to filter out the keyboard warriors who find something wrong with everything, and get good information. I'd like to stay with a US company if possible, but want these to last. I came across the rebuildable HD set by Dynatrac, but they're pretty pricey. I'll see if I can find what Phil used in his build.

Navigation

[0] Message Index

[#] Next page