TOOLS, CONSTRUCTION, ALTERNATIVE ENERGY > Hand Tools, Power Tools, Welders, etc

New Champion Compressor (from burb build)

(1/4) > >>

JR:
 OK, this is from my 2500 swap thread when I got the compressor.

JR:
Not in the tool section, but I need a bigger/better compressor and I wanted to go local so I got this. No not a pallet,,,,,,,,,,,,,,,

Hooked it up after lifting the front with ramps and airing down the rears. Much easier to pull out flat vs up.

My little HF did a great job!!

JR:
That lift is a 2 ton and has done about everything form tree trunks so the 2 floor lifts I slid into the other garage after stacking and setting on car dollys.

Lifting the 700lb Compressor was childs play.

JR:
I then spun her around (why are they always women??) and set her down.

Lifted it from the top and tied it off to my dmax so it could not fall.

JR:
All set up nice and safe (until I move outside) ready to be refilled with oil (drained for laying down) and a more break in after wiring.

Got it for just over 2K and it should easily out perform my 20 year old 5hp Craftsman with an Alum pump.

This is 5hp too, but the motor is about double the size, magnetic starter, starting unloader and rated at 175psi and 17cfm@175psi and just spins at 720 rpm.

Navigation

[0] Message Index

[#] Next page