Pages: 1 2 [3] 4 5 ... 10
21
« Last post by Atkinsmatt on May 18, 2024, 08:20:10 AM »
Acts 1:8 ESV
[8] But you will receive power when the Holy Spirit has come upon you, and you will be my witnesses in Jerusalem and in all Judea and Samaria, and to the end of the earth.”
22
« Last post by JR on May 18, 2024, 03:29:36 AM »
HOA must love both the tractor and camper in the driveway.
23
« Last post by Flyin6 on May 17, 2024, 08:32:42 PM »
Oh, and the folding aluminum steps just showed up. I am no fan of the factory "Lunge and reach for your life" Factory single step. Good for a long ballistic stretch and for falling and twisting one's ankles, but little else.
24
« Last post by Flyin6 on May 17, 2024, 08:31:04 PM »
There is quite a bit to come in the next 6 weeks before launch, but for now here it sits:
25
« Last post by Flyin6 on May 17, 2024, 08:29:52 PM »
And just so I have a photo reference, here is the factory-installed Renogy LiPo 100 Ahr battery:
26
« Last post by Flyin6 on May 17, 2024, 08:28:25 PM »
Everything worked when hooked up in the truck and the camera immediately paired to the monitor, however for some reason, I cannot get power to the camera from the supplied wire in the camper...Hmmm
I have sent an inquiry to Forest River to help sort this out.
27
« Last post by Flyin6 on May 17, 2024, 08:26:56 PM »
I will mount the 7" monitor screen from one arm of my dash-mounted Bullit mount system. I am currently awaiting a 20mm ball to complete that mount setup. Ram conveniently provides a 12VDC power source right at the mount site!
28
« Last post by Flyin6 on May 17, 2024, 08:24:42 PM »
Four screws later and the factory cover is off, and you can access the wiring. In my case I had to unclip the factory harness back to the receptacles and reinsert the new camera wires.
Then you tuck in the wires and reinstall the camera.
29
« Last post by Flyin6 on May 17, 2024, 08:21:55 PM »
It fits in a prewired factory spot:
30
« Last post by Flyin6 on May 17, 2024, 08:20:59 PM »
I picked up a Furion back up/rear view camera:
Pages: 1 2 [3] 4 5 ... 10
|
Recent Posts