11
« Last post by Flyin6 on May 20, 2024, 09:53:36 AM »
Neighbors have a new trailer with those windows, look nice. Sounds like how a mini split works.
What is a "space end"? Guess you mean a "spade".
Yes spade end... These new rooftop dometic units are actually heat pumps...Run in both directions. AC now and a tad bit of heat in the chilly months,
12
« Last post by Atkinsmatt on May 20, 2024, 08:19:09 AM »
1 John 4:9 ESV
[9] In this the love of God was made manifest among us, that God sent his only Son into the world, so that we might live through him.
13
« Last post by JR on May 19, 2024, 07:44:49 PM »
Yep, caught it early enough. I have some water based rust/primer that will get sprayed over it after basic cleanup, then coated.
Little work on it today, put a rear bumper on the sons truck. Was from my fathers S10 blazer so the reuse is cool.
14
« Last post by JR on May 19, 2024, 07:20:07 PM »
Neighbors have a new trailer with those windows, look nice. Sounds like how a mini split works.
What is a "space end"? Guess you mean a "spade".
15
« Last post by Flyin6 on May 19, 2024, 06:30:01 PM »
Playing with the flush mount windows. They work exceedingly well!
16
« Last post by Flyin6 on May 19, 2024, 06:29:04 PM »
BTW, the thing was all wobbly, so I set it down on two automotive jackstands and a 52" piece of 2x6 fir and got most of the wiggle out of it. It is resting solidly in those jacks while still having all the electric post jacks still contacting the ground as well.
17
« Last post by Flyin6 on May 19, 2024, 06:27:17 PM »
After that, I buttoned it all back up and with only an extension cord running from a 15 amp wall receptacle, I turned the thing on.
It ran flawlessly for about 35-40 minutes, when, fully satisfied it was working without issue, I turned it back off again.
This is a huge success, which means I can carry just my small 2K HF generator to power the AC if needed during this summer's adventures...Yippee!
18
« Last post by Flyin6 on May 19, 2024, 06:24:50 PM »
You will need to crimp on several spade ends, male and female, but after that, it is nearly a "plug and play" affair.
Apologies for the "ugly-foot" photo bomb!
19
« Last post by Flyin6 on May 19, 2024, 06:22:55 PM »
Next, I removed the control center access cover where the capacitor is located.
20
« Last post by Flyin6 on May 19, 2024, 06:21:56 PM »
The installation is straightforward and not difficult, although some parts of the install can be a little "worky."
I start by pulling off the fiberglass cover from the 10K roof-mounted unit.
|
Recent Posts