0 Members and 1 Guest are viewing this topic.
Here's the door painted and dried, two coats
I just don't want to wind up missing a digit or limb. I can sometimes get in a hurry to get results.
Sam:THATS THE INSIDE! Snowblind? Stop down and visit some green/brown scenery to reset your vision there buddy!
Need to fab a place to secure the door bars on the door or attach with a wire that they hang from when not installed. Otherwise a ranger will set it down and you’ll never see it again Sent from my iPhone using Tapatalk
Quote from: cudakidd53 on January 26, 2018, 05:40:28 PMSam:THATS THE INSIDE! Snowblind? Stop down and visit some green/brown scenery to reset your vision there buddy!But it was white...
Don I have something like this in mind, weld a washer or something round so you can get a length of plastic coated wire from the local HD and a few of those compression clamps for said wire. Make a loop at each end. Eye bolt and a loop of cable attached to the swinging door, loop of cable through the t handle so when the t handle isn’t used it dangles but not lost Sent from my iPhone using Tapatalk
So, Bobby...being the calculating trained warrior NCO that you are. Take the appropriate action, Execute!
your standard grunt level CQB is just putting rounds and rounds on scary stuff till it stops scaring you!
Cool. That house looks bare, didn't you say the foundation was solid?
Don do you use a truss calculator or do you just wing it? (Get the pilot joke?)Sent from my iPhone using Tapatalk