As many of you know the power company ran all new gas lines a few months back. In that they replaced a pad by my meter and at my request made it longer for my compressor, causing a little step where the gate was. Fast forward to today I finally measured out for the compressor and found I will need to trim about a 1x2' section. This gives me a nice little ramp where the new 40" gate will be. Plus I can park the manlift over there for now.
So here is where I am starting. Using my ol HF 7" grinder with a masonry blade. After cutting around the edge I decided to use water. Made a little mess, but no dust and it cut way better.