0 Members and 1 Guest are viewing this topic.
Recommended to get the factory bushings or if there aftermarket? I ended up doing some major rust removal on my rear diff last night also. Then applied a rust inhibitor and Re sprayed it black today. I think that will be the project for the next few free Eve's. Need to clean a lot of frame sections too I also noticed my leaf spring bushings are pretty toast too. Need to look at the cost and advantages and disadvantages of the rubber vs the silicone Raising boys into RealMen!!
That's makes sense. I have removed one set of bushings from leaf springs in my life. I used a lot of swearing and more hammer then I felt it should have. Ideas after looking at it 1. Fire2. Pull leaves out and use a press3. Use a sawzall and cut sections out 4. Get with atlas and get some military wrapped new leaves and call it a day. 5. ? 6. ? Other ideas? Raising boys into RealMen!!
It's a big c clamp. A hollow cup on on end to receive the bushing and the screw side pressing on the bushing. No different than using them to press an a arm bushing. Sent from my iPad using Tapatalk