8
« Last post by Flyin6 on Today at 07:01:56 PM »
Installing that Carli piece is not all that easy.
The cylinder is gas-charged to around 200 psi, I think. Anyway, compressing it is not for someone recovering from RA!
The tricky part is that there are four little alignment spacers that fit either side of the heim joints. So while compressing that thing and trying to line it up, one needs to somehow slip in the bolt just a little ways, then get it through the first bushing, then the Heim, and then the fun begins. While you are pushing the thing to compress it, with your third and fourth hand you need to force in the lower spacer...to where it aligns with this spring-loaded bear trap, then get that bolt through the second (pinched in place) bushing then through the mounting ear.
If you can do that, well kudos to you because I only got it after some focused praying and zero cursing or bad thoughts.
Get that done and you're nearly finished. I did not torque, just got everything snugged up. The locking nuts will keep everything in place, but if you read of a dually careening off a mountainside with a lop-sided camper on the back, well, I guess it loosened back up!