VEHICLES, CAMPERS, and BOATS > Build Threads

Don's 2024 Ram 3500

<< < (25/35) > >>

Flyin6:
Today I got after the Carli suspension parts I just purchased from Tater. Most of the stuff was delivered, enough to get the front end almost completed.

The idea is to level it, the same as I did on the 2022 single wheel 3500

Carli lifts the front 2.5" and the rear 1" to level everything.

Here are some before and after shots

Flyin6:
I call it 40 7/16" before the Carli springs
and
I measured it at 43" even afterward.

Carli says their springs lift it 2.5", I actually measured a 2 7/16" lift.

Pretty close

I started by jacking the thing up and pulling off the wheels on the front.

Flyin6:
After removing the front cross bar, and disconnecting the shocks, the front can be lowered enough to pull the springs out.

Flyin6:
Panhard or front centering link or whatever it is called has to be setup and adjusted. It is a bit of a process, but I had done one earlier on the blue truck, so this one went together faster.

Flyin6:
Factory vs Carli springs:

Navigation

[0] Message Index

[#] Next page

[*] Previous page