Hello Guest
Home

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - KeithB

Pages: [1]
1
Firearms / Laser engraving weapons
« on: August 20, 2016, 10:33:41 AM »
Hi every one. I know I haven't posted anything for a while, busy with life and all but I have recently started a new side business. I do laser engraving, cutting, etching and marking. I have been talking with Don about it  and showing him some pix of the jobs that i have done, including weapons, and he has  given me the honor of doing some work on his present last year from the Mrs. the SIG 716 .308.
Don thought it would be a good place to post this new project on the site for all to see. He hasn't seen the results of the yet so this might be his first time seeing the results of it as well. Here arer some before and afters. I also took a video and will try to post as well.

2
Ammo & Reloading / Enjoying my Christmas present from the wife.
« on: December 26, 2015, 11:02:53 PM »
It might not be a new weapon but it was just what I wanted, reloading equipment.
A Lee load master with 9mm, .45, .223 and .308 dies and some other accessories, case feeders and some case prep tools.

I built the bench while I was off work recovering after a surgical blunder and a bad case of staph infection. But that has healed after 8 weeks of IV antibiotics.

So while waiting on my powder order I figured I would start some case prep on all the brass I have saved. I'm on my last 100 of .308, depriming so I can trim cases and get rid on the crimped primer pockets on the mil spec brass. But I he time the powder gets here I'll be ready to start to work up a load for the Remy. Then some bulk loading of 9 mm, .45 and .223.

Since I'm just starting to reload any advice is welcome.

Pages: [1]
SimplePortal 2.3.6 © 2008-2014, SimplePortal