0 Members and 1 Guest are viewing this topic.
I just don't want to wind up missing a digit or limb. I can sometimes get in a hurry to get results.
I was wondering if that cartridge segment might be undercut to capture the bullet and base?
I am building one of these right now. In the test fitting before gluing it together stage. It has a undercut for sure. I don't have a router so I used another method.
I was eyeballing that thing with an ideaFirst idea, do two ends, one for a standard 30 round mag, and one end for a 60 round surefire magMy second idea is to build a table, for the farm, and make that a drawer you simply pull out to load up
Quote from: Flyin6 on August 14, 2015, 06:50:36 PMI was eyeballing that thing with an ideaFirst idea, do two ends, one for a standard 30 round mag, and one end for a 60 round surefire magMy second idea is to build a table, for the farm, and make that a drawer you simply pull out to load upThink of this option Don - create a double well shared by both magazine sizes. Removable cross bar for bottom of 30 round mag. - then just run and load the 30 round tray side twice. 60 arc is probably too big to fit the curve into a board.