I have been looking for a wider cabinet for my Wabeco mill. It was a CNC mill and will be again but it needed a better home than the 30in cabinet it was on. I have done a full RnR on this mill after a garage fire, that left it in bad shape and cooked the CNC parts.
So I found a 46in wide x 24 deep Husky cabinet last week. I had also wanted something with drawers vs the shelves for access. Plus at $350 vs the 1000+ I have been seeing it was an easy decision. Siting on the old 32 inch cabinet the tray and X bedway hung off the sides while working.
Had a buddy at scouts make me a galv cover for it that fit great and the youngest and I did the swap today. I already had an attached chip tray that got in the way a little, but we got it.
I need to reconfigure the wheels on my cherry picker as they won't go under the cabinets, but that is for another day.
Started by cleaning it off some and wrapped a lift strap around the motor. This is a tabletop mill but still goes at around 200lb and is solid. We added double tape to tray under just the mill base. Then we centered and dropped it down, using a piece of flooring to get it centered before setting it down. I will then add a silicon bead around the tray keeping the nasty's from under it.
I had to use wood and clamps to hold it as I slid the flooring out. Rear mark was a little off but it was dead on in the front and the rear was flush with the cabinet back so I was happy.