0 Members and 1 Guest are viewing this topic.
Taking shape nicely. Sent from my iPhone using Tapatalk
Plus your still doing the regular business, right?
Happy Anniversary
Shawn, that was the same Plasma table I ordered and canceled. Supposed to be great units. Did you get it with the recommended cutter and 3rd axis? Kinda wish I had not cancelled but space is an issue at home. I may look at the Lincoln unit too now, they are based in Sparks with showroom.Enco is based in NV and is OK unit (chinese). I think they changed the one letter (EMCO) which is the lathe I have. I had a 13/40 jet gab bed that was not bad. It was made in china. I had another made in Taiwan that was tight but to small (9x20) Love to see this all setup!!!
Looks like you work with axles now and then,,,,,,,,,,,,,,,,
Very similar to my Grizzly... the stand looks identical but green.This is what I used on my recent service a couple weeks ago, for the gear box and ball oilers:Mobil - 100817 DTE 26, Hydraulic, ISO 68, 1 gal. https://www.amazon.com/dp/B00PM9KTC8/ref=cm_sw_r_apan_glt_fabc_WZSQDPFVW5K7S354QJW7?_encoding=UTF8&psc=1And this for the ways : Mobil 100772 Vactra No.2 Way Oil... https://www.amazon.com/dp/B07B7XZKVF?ref=ppx_pop_mob_ap_share
Shawn, Shawn, Shawn….so much fail….seriously, something to consider here, some rubber isolation pucks between the wood and the metal every 16 inches may serve you well to reduce vibration and noise from the compressors.Looking good, carry on!Sent from my iPad using Tapatalk
So, the massive steel structure wasn't strong enough so you had to add a years pay worth of wood?Yes, I'm jealous
Just use a good amount of glue, lay all the sheets on and then follow the profil with a router and bearing. No cutting needed unless you joist spacing is off somewhere Sent from my iPhone using Tapatalk
You said you had some cutting to do, I wouldn’t try and cut those angles, I’d run a flush cut router bit and you will have a clean line that follows the framing. As long as you joists are spaced correctly you should only need to cut the one side and the angle section on the garage bay side Sent from my iPhone using Tapatalk
Yes, black hides stuff but will make that area dark. I can see treating the beams, but do the ceiling in white.
LED of course? Nice
I just got all mine up except for the last two outside lightsThanks for the link!
Yet,,,,