0 Members and 2 Guests are viewing this topic.
don, that is the most intense bumper i've seen short of a russian dreadknot class train. you remember the original cow catcher square d came with? can you post side by side pics?
that is awesome. come a long way! now we can all see the crazy amount of change and work put in. love it and well done. carry on!
I just don't want to wind up missing a digit or limb. I can sometimes get in a hurry to get results.
Looking good Don...I am looking forward to the next phase.
That firs bumper was ugly, but I bet it would do the job.9000 rnds? Must have been 7.62 as 556 would only weigh 270#, about a dressed out soldier. Still, 90 seconds from both could do lots of damage!!
Quote from: OldKooT on May 28, 2015, 07:14:05 AMLooking good Don...I am looking forward to the next phase. I think we're all hoping the next phase is the Start It Up phase!
"That would get them moving or get them shot, one of the two."This cracked me up... Pretty much straight forward, move or get shot, lol....
Sweet and I like the reinforcements,,,,,,,,,,,,,,,,,,,,,Adding a bar on the lower tube outriggers would match the center upright nice.
Since you're drawingSee that section of grill running down inside of the headlight and parking light?What would it look like with a new vertical there along with a lateral which passes just under the headlight, connects to the vertical, then another horizontal coming off the stub on the middle horizontal?That along with something like that corner gusset would "Grid up" and tighten up everything considerably
who left the box crayons open for these 2 to play with?!just kidding guys, sometimes you have to get a little old school to have it make sense.
I like some of the upper tubes I see already, but here is where I mean on the tube supports.Cap them like the pushbar uprights.