Getting there. Dodge has always had solid running gear. Some of the earlier auto trans were not up to snuff and not a huge fan of the AAM front axle.

Stock wheels look good too.

Doing steps on it too? I sold my powersteps as I prefer the side protection of the stationary.

On the steps, dunno.

It came with the cheapo side steps and actually, they do work.
My oldest son says I need to lose them.
I would prefer AMP Research steps for this one, but again, dunno...

Opinions?

Added this over the weekend.  96" cut Toro Z master.  Still have the 60" as well.

That is a monster.
Hope you don’t have any ponds.
I hear they are magnets for mowers…

Yep, you need a permit to cut down a tree in the city normally, not to trim. I still have some touch up to do but solar production is up almost 5k today and yesterday.

Dang Sam, maybe better springs vs trimming the frame?

I had to attend a fire department board meeting, so I did not finish.

Chatting with the guys at the truck shop, they told me that my airbag leak issue is being caused by leaking swivel fittings. They do not use them but have some better stationary solid brass fittings. They just gave me two of them for no charge. How cool is that?

So here is the resting condition as of COB, today. I'll get on the bags tomorrow and hopefully, have it ready for the alignment shop.

Very quickly, I noticed the warehouse guys sent me the wrong U-bolts, so I had to go out and have some made up for me. Having to take a couple of hours to chase down the U-bolts effectively killed any chance I had of finishing the install today...

In the box, you can see the Carli-supplied U-bolt, and the one I just took off my truck. They are the same length!

So is life, no big deal.