First off I had the kids to watch while doing this second door
First things first is order what you need from your favorite company. I use a1auto.com there are many similar.
I made a mistake and ordered them with out the motor. (Bone head move and saved nothing)
https://www.1aauto.com/window-regulator-pair/i/1awrk00005Tools needed,
Mini impacter, 7mm,8mm, 10mm and Philips screw driver and tool attachments
Razor knife, parts cleaner, cool kids to be in the way
Next was to remove things to get to the door insides
First remove the manual lock slide ( it should pop out with a plastic pry tool. Second is the door handle cover, then pop the screw cover off, than pull the plastic barbed screw.
You will need to loosen screws in this location. But I removed the door already
Next you have to lift up the door panel about a inch to pull it away from the door.
Than you have multiple wired connections to remove which a second set of arms and eyes are helpful for which I did not have. One plug is the swinging clamp like our main wire harnes on the motor that you open to put almost any EDge product into. Then three others that require a flat blade screw drive or long girly fingernails DONT! Forget the light in the bottom corner of the door!
Then you need to set the panel aside, and begin to remove plastic from the door to access stuff. Mine has Been on and off for speaker stuff and sound deading so it’s held on by speed tape.
You next need to tape you glass in place as you are removing what holds it in place. I just taped it on the outside because of window tint, to the top of the door so it wouldn’t fall.
Cut holes here
Then loosen these screws
these two are the clamps that hold your glass. Be careful
Sent from my iPhone using Tapatalk