This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Bigdave_185
Pages: 1 ... 57 58 [59] 60 61 ... 154
2901
« on: March 10, 2020, 01:41:48 AM »
I stood in line at the local pharmacy for 1 3/4 hours to pick up two medications. I couldnt get the doc to write me a extra prescription if I wanted too, gonna see if the doc will write my wife one so I can have back up.
Sent from my iPhone using Tapatalk
2902
« on: March 09, 2020, 08:13:45 PM »
Our Costco has been out for a long while, water bottles and t p
Amazon will drop ship you a box of tp. Did that and freezers are stocked with wonderful smeats.
All good at my home but scared for my co workers who barely make it by week to week
Sent from my iPhone using Tapatalk
2903
« on: March 09, 2020, 12:51:18 AM »
Are you saying I had better buy up the supply of top Roman and more toilet paper?
Sent from my iPhone using Tapatalk
2904
« on: March 08, 2020, 10:51:21 PM »
And total investment to date Jr?
Sent from my iPhone using Tapatalk
2905
« on: March 08, 2020, 10:50:26 PM »
Will the actuator be on the inside of the V or the outside/pointed side?
Sent from my iPhone using Tapatalk
2906
« on: March 08, 2020, 10:47:33 PM »
And look who showed up again!
The grease that I remember being on the plywood is causing me some issues. So my next step now is to take the area back down to wood, then spray it off with brake cleaner, then repeat the process as many times as necessary until I achieve a solid base to apply the two stage urethane bed liner top coat
In past instances with fighting a grease or oil I found the sandpaper was still spreading the grease and most affective was to sand back to wood and prime with Kills spray can primer. It’s mean stuff and might be the answer Sent from my iPhone using Tapatalk
2907
« on: March 08, 2020, 10:40:26 AM »
For sure.
Sent from my iPhone using Tapatalk
2908
« on: March 08, 2020, 03:19:11 AM »
Did you ever get your cooler you ordered?
Sent from my iPhone using Tapatalk
2909
« on: March 07, 2020, 09:49:18 PM »
Lights looks really good, great output
You said there is a part you want to laminate? What is that part. I can’t tell from the photo. Your interior looks great
Sent from my iPhone using Tapatalk
2910
« on: March 06, 2020, 09:21:22 PM »
So much green surrounded by brown
Sent from my iPhone using Tapatalk
2911
« on: March 06, 2020, 09:20:52 PM »
Let’s turn off The shop lights and leave on those pod lights.
Sent from my iPhone using Tapatalk
2912
« on: March 06, 2020, 08:44:14 AM »
Lol I like the name tag
Sent from my iPhone using Tapatalk
2913
« on: March 05, 2020, 09:28:27 AM »
Ken said “nipple” lol
Sent from my iPhone using Tapatalk
2914
« on: March 05, 2020, 09:26:18 AM »
When insulating the roof area, I seen the insulation doesn’t come flush with the studs. Air gap or going to fill it up more?
I have been wondering which direction would the air gap best be served? Inside the trailer or outside? Before rotomold coolers there was simply a air gap and plastic. The super eco homes will build up air gaps between the siding and the outside sheeting.
Just curious on others and your thoughts.
Sent from my iPhone using Tapatalk
2915
« on: March 05, 2020, 09:22:42 AM »
Well if it’s been a proven method I guess we can look past it ;)
Looking forward to an excuse to go back to Moab this summer. Let’s all make it happen
Sent from my iPhone using Tapatalk
2916
« on: March 05, 2020, 12:26:48 AM »
When do we see the wheelie ?
Sent from my iPhone using Tapatalk
2917
« on: March 04, 2020, 07:17:30 PM »
Don’t forget the wooden fuse block distribution block
Sent from my iPhone using Tapatalk
2918
« on: March 04, 2020, 08:11:17 AM »
We have much of the same In Utah. Cabinet shop needs dust masks if anyone wants to ship me a box lol
Sent from my iPhone using Tapatalk
2919
« on: March 03, 2020, 10:23:04 PM »
After watching that series. Frank will never die !
Sent from my iPhone using Tapatalk
2920
« on: March 03, 2020, 10:21:19 PM »
That’s as far as the dodge made it, keep going you can complete it!!
Sent from my iPhone using Tapatalk
2921
« on: March 03, 2020, 09:25:21 AM »
Monday has come, how did the dyno go ?
Sent from my iPhone using Tapatalk
2922
« on: March 03, 2020, 09:24:51 AM »
That’s a whole lot of brushing Don. Looks good!!
Sent from my iPhone using Tapatalk
2923
« on: March 02, 2020, 04:18:50 PM »
I need to do some more looking about on it but I think so, It needs some new belts and some lube. I’ll tear into it one of these days. Need the Honda to work
Sent from my iPhone using Tapatalk
2924
« on: March 02, 2020, 01:49:16 AM »
I believe it’s a 77 but need to verify the Sn
Sent from my iPhone using Tapatalk
2925
« on: March 01, 2020, 11:06:44 PM »
One more trailer epoxy pour done  Friends 18ft enclosed. Used primarily used for his Can Em Also picked up this new garden tractor  Sent from my iPhone using Tapatalk
2926
« on: March 01, 2020, 11:44:41 AM »
I pulled two of the three and cleaned them but the main I didn’t get it cleaned. The floats were sticking at first and pouring fuel everywhere. That was my first fix, now to pull it apart and clean them all. Looking at some of this stuff  Sent from my iPhone using Tapatalk
2927
« on: February 29, 2020, 01:25:26 PM »
Pressure washed off the Honda and added some fuel, it fired first kick. But.... the floats must be sticking and the fuel pours out of the hoses
Sent from my iPhone using Tapatalk
2928
« on: February 29, 2020, 11:31:05 AM »
A lot of our guys equip has screens and backup cameras, works ok until the lens gets covered in dirt
Sent from my iPhone using Tapatalk
2929
« on: February 28, 2020, 12:53:22 AM »
It looks like you did an amazing job on that motor bay!!
Sent from my iPhone using Tapatalk
2930
« on: February 28, 2020, 12:52:20 AM »
Started another project this week 2002 Honda XR200R  Ordered some tubes, tires, throttle cable, brake&clutch cables, air filter. Cleaned the carburetor tonight. It was really froze up but good to flick now. Pressure wash the frame and motor off tomorrow and re assemble Sent from my iPhone using Tapatalk
2931
« on: February 27, 2020, 09:43:15 PM »
Changed the oil out of the duramax today, replaced the Fass fuel filters on the pump, need to replace the factory fuel filter still.
Garage smells proper diesel fuel and exhaust mixed with stinky 10k diesel oil.
Sent from my iPhone using Tapatalk
2932
« on: February 27, 2020, 07:45:44 PM »
Sprayed the remaining 1/4 alder for the trailer One coat sealer, heavy coat of lacquer  Sent from my iPhone using Tapatalk
2933
« on: February 26, 2020, 11:39:19 PM »
Which awning did you choose? Matching to the burb?
Sent from my iPhone using Tapatalk
2934
« on: February 26, 2020, 08:47:25 PM »
I think that’s why nick has set his pace, sooner it’s done the sooner it’s gone.
Sent from my iPhone using Tapatalk
2935
« on: February 25, 2020, 10:55:51 PM »
Noticed the lED lights in your last photo, been reading reviews on the amazon and honestly kind of scary with photos of burnt circuit cards and smoked wires.
Little bit nervous to pull the trigger on the purchase and thinking I’ll spend a little bit more for no fire insurance in my trailer
What did you find?
Sent from my iPhone using Tapatalk
2936
« on: February 25, 2020, 10:52:25 PM »
Sounds like you had better show up with a box of donuts for breakfast or they are going to have it done before your get there!!
At this rate your tires will still be in warranty and they won’t be dry rotted
Sent from my iPhone using Tapatalk
2937
« on: February 24, 2020, 04:43:28 PM »
 Sent from my iPhone using Tapatalk
2938
« on: February 24, 2020, 04:38:11 PM »
Took a snowboard day. Snowbasin Utah. The home of the fastest recorded speed of the Olympic down hill.  My cousin from Minnesota came to ski for the weekend and asked if I would show him around. I officially call myself old when I can’t hang with these young kids. I am long past done at 1:30 Good day anyway   Sent from my iPhone using Tapatalk
2939
« on: February 23, 2020, 08:56:19 AM »
I couldn’t get our video to upload yesterday but today works, we poured 70 pounds of aluminum yesterday for his senior project at WSU and had some really great returns on our efforts. I made the cop and drag for them to pour in, the school didn’t have one large enough for the center logo. 8/4 poplar with finger joints at each corner, brass pins and glue to hold them together.  https://youtu.be/jsXH-OlsZLMSent from my iPhone using Tapatalk
2940
« on: February 23, 2020, 08:42:05 AM »
Besides the two handrails I like it, I’d probably pull on off at least
Sent from my iPhone using Tapatalk
2941
« on: February 22, 2020, 03:40:14 PM »
  Sent from my iPhone using Tapatalk
2942
« on: February 21, 2020, 09:52:03 PM »
Have you ever seen how the semi trucks heat the cabs? Happybuy 3KW Diesel Parking Heater 12V Diesel Air Heater 3000W Diesel Heater Double Mufflers with LCD Thermostat for RV Boats Car Bus Caravan Motorhome https://www.amazon.com/dp/B07L88ZJMS/ref=cm_sw_r_cp_api_i_nLkuEbWQBA72SI know the thought is a little late but with blown air being dry with no CO2. The propane unit will cause moisture Sent from my iPhone using Tapatalk
2943
« on: February 21, 2020, 11:26:09 AM »
Looking over at the latest gun question post: what and where are you mounting your pistol grip12 in this camper? Hideaway box, very visible mount above the door with glowing tape around it?
Handgun under the night light?
Sent from my iPhone using Tapatalk
2944
« on: February 21, 2020, 11:23:20 AM »
I was just curious, installing all of kitchen crown in the homes. I have tried to weigh out the options of one finial coat on everything in place, doors, end panels and crown but I always come to the same conclusion, masking takes to much time, cure times are long for other trades, smell of lacquer is bothersome to others. But as you stated. Space is probably the limit.
What happened to you killing down a bunch of your own cedar from the farm? I imagine that would smell fantastic
Sent from my iPhone using Tapatalk
2945
« on: February 21, 2020, 09:09:00 AM »
When ever I run a bunch of white oak it smells the shop with what I think smells just like pickles. Poplar smells like fresh brownies or the garbage can pending on a condition I can’t pinpoint.
Is your tongue And groove rough or paint ready smooth?
You could pre spray large amounts in full length sticks and then touch up as needed afterwords also
Sent from my iPhone using Tapatalk
2946
« on: February 20, 2020, 09:54:16 PM »
 Roof panels Sent from my iPhone using Tapatalk
2947
« on: February 19, 2020, 09:58:48 PM »
Buy goats
Sent from my iPhone using Tapatalk
2948
« on: February 19, 2020, 03:12:36 PM »
You mean a actual pay check lol
Sent from my iPhone using Tapatalk
2949
« on: February 19, 2020, 01:12:05 AM »
The transport brought my roof material, the managed to break two of the seven 1/4 inch alder panels with the fork lift. I should be Able to start spraying those tomorrow or the next day
Sent from my iPhone using Tapatalk
2950
« on: February 17, 2020, 10:02:36 PM »
Yep!
Sent from my iPhone using Tapatalk
Pages: 1 ... 57 58 [59] 60 61 ... 154
|
Show Posts