0 Members and 11 Guests are viewing this topic.
You might not be able to tell, but a lot of wiring has been attached and routed that was hanging loose in the breeze a day or two ago
One persistent problem, though, is with the ARC switch panel. I just cannot get it to work. I have tried everything three times already!I now believe the relay panel or cable or switch module is defective. It should have worked at some point while I sorted through it. I even double grounded the thing with no luck!
So why not spray bed liner on the floor of the cab? Everlasting and it also works as a sound deadner and an insulator?
Don I run H4 Bulbs in my trucks. They are hellish bright and very simple/reliable. A bit old school, but then I tend to roll that way LoL
Quote from: Flyin6 on March 20, 2015, 09:36:46 PMOne persistent problem, though, is with the ARC switch panel. I just cannot get it to work. I have tried everything three times already!I now believe the relay panel or cable or switch module is defective. It should have worked at some point while I sorted through it. I even double grounded the thing with no luck!Try to run a simple circuit through the switch panel and then the relay panel independently. Isolate a single switch or relay of possible. Its easy to get something crossed up when you are working with a bundle of wires. I doubt its either the switches or relays. I like to wire one circuit at a time and test each one before moving on to the next. Tedious, I know...
Ooooh, new compressor. Do Tell!
Don, with the new reflector headlamp housing you could just run 100watt bulbs too. Same thing I am doing on the burb. Lots of choices and plenty of light and you can find a replacement anywhere.How long do you think your carpet is going to last in this thing?
Have you tried using a heat gun to flatten out the wrinkles in the vinyl mat?
http://www.summitracing.com/parts/hla-h71070201/overview/
Don....these folks are well thought of. I personally have no experience with them FWIWhttp://www.stockinteriors.com/AutoCarpet.asp?Itemid=19452&MakeId=33&ModelId=160I am unclear yet what I will do with the crew cab. Carpet is most likely not an option in this land of dust/mud.
Very nice Don. Is there any concern with the main power cable down there in harms way? Sure you are going to put a KIA Killer bumper there but that could get pinched off with just a little bend the wrong way?What site did you get those louvers from?