0 Members and 2 Guests are viewing this topic.
Especially in your work situation, a winch will make you brave so you can get stuck farther from the road.
So, Bobby...being the calculating trained warrior NCO that you are. Take the appropriate action, Execute!
your standard grunt level CQB is just putting rounds and rounds on scary stuff till it stops scaring you!
I like it.
I just don't want to wind up missing a digit or limb. I can sometimes get in a hurry to get results.
^^^ Three wise men thereI'd take their counsel!
Good start. Don't forget to add some lateral bracing as even that 1/2 plate will not be enough.
Are you using the mig with gas or flux core?Flux core will give you a deeper weld vs gas. In the meantime a good old stick welder will work for those deep welds too and not break the bank. A good bead using 5/32 7011 will yeild a great weld and the flux will roll right off.
Looks much better and the welds are picking up too. Is the wire a diff number or just brand?
Just brand. Same .035 flux core. This HF stuff is much darker color than the Hobart. The Hobart is silver. I even double checked to make sure I didn't have non flux core Hobart. But they are both the same specs. Sent from my iPhone using Tapatalk
It was fairly old and the whole spool seemed to be the same way. My heat is as high as it will go. I have just been running the beads pretty fast on the plate. I could probably get a hotter bead if I stayed in one place a little while longer before moving. Sent from my iPhone using Tapatalk
I like this project because it's simple, practical, affordable and unlike mine, will probably RUN!
Dealing with that in the sub I am flipping. So many wires from the alarm and it turns but no spark or fuel. At least I have another to compare!