I'm new and the truck has been modded over the last several years, so I'll try to keep track of everything and post up what pics I still have.

Bought this 2005 2500hd new and it stayed stock for about 6 months before I started in on it (which amazed all my friends and family).

Here it is in all it's stock, little tired glory. Shiney and all



Poser pic in front yard on 33" tires.



Initial mods were 33" tires (from 29" stock), AEM Cold Air Intake, Wheatly Tune, dual turbo mufflers

Added Westin side steps (removed later)



Unfortunately don't have a lot of pics of front bumper build. I use a lot of scrap steel and frequently buy it at the scrap yard for future projects and don't even know what I'm going to use it on at the time lol.
The subframe for the bumper is 6" C channel w/.25" 4x4" flat plates and two angled legs made from 1.5" .25" wall square tube welded in figure 8 fashion (center section of leg is now .5" thick)
The skin is made from a piece of .1875 (3/16") plate that started life as a blank for a school bus bumper. It had very nice shaped "D's" hydroformed into each long edge. The D shape adds considerable rigidity and strength. I plasma cut pie wedges out to get the shape I wanted overall.



To be continued