0 Members and 39 Guests are viewing this topic.
I feel like such an "ass" for posting that picture........ ;D
Where did the like button go on this app. I haven't done anything to her but efi. She has handled well for 50+ thousand miles Raising boys into RealMen!!
wish I had the coin for a mike L trans
So, Bobby...being the calculating trained warrior NCO that you are. Take the appropriate action, Execute!
your standard grunt level CQB is just putting rounds and rounds on scary stuff till it stops scaring you!
was he driving your duramax bear?
You guys are going into tow/haul mod when pushing it, right? That alone tightens up the shifts and raises pressures. Us guys with the older (06) trannys need the trangojr be the same as you later model guys.
Eagle 059s in black and nitto exo grapplersSent from my iPhone using Tapatalk
Ken. I didn't tell you I'm 3 feet tall. LolTR. very much a change from my normal I.T. Desk job. Still have a lot to do. This is my plan. It will have another row of stringers about 6" up from the bottom of leg post. That will make it solid. I also have heavy duty locking casters and some heavy bolts that I will make for leg height adjustment. Should have about 1.5" of travel so I can make any concrete floor level. That's the hope anyway. I'll create plates for the bottom of leg and drill 1" hole for bolt. Then weld nut and washer on inside before I weld plate on bottom of leg. Then I will cut another plate and weld bolt head to it. Then I will weld caster to it. That should give me adjustment at each corner and should be nice and stout. See simple! If only I can keep everything square and level while welding up. Once I get the base and top plate connected (I'm using 12M x 30mm countersunk fine thread bolts for attaching top to base) I will lay out grid of 5/8" (16mm) holes to use as hold down points similar to strong hand type of tables. Then I will also make the center of the table have a radius style of hold down holes pre set for angles. I can't find the design right now but will post when I find it. Also 4th of July weekend I set up the lighting for the area. I have one stubborn fixture but will tackle that when I have time. More to come. Sent from my iPad using Tapatalk
I will have to weld in a fire extinguisher mount if I do. Sent from my iPad using Tapatalk
I just don't want to wind up missing a digit or limb. I can sometimes get in a hurry to get results.
You just reminded me of your four seasons9 months of ice, two weeks of thaw, then the bug season, then two weeks of fall, then the freeze again!That about right? ;-)
Drove 10 hours today back to Texas. Wife was feeling miserable from altitude sickness. Oxygen and advil were not helping. We cut it short. Going from sea level to 8700 was a bit much
Just curious. Who all is a NRA member here? What are you guys doing in a political sense to protect your rights to bare arms Raising boys into RealMen!!
I'm a lifetime NRA member. I don't like everything they do but the fact that the left constantly derides them means they are doing something right. They drive a lot of legal challenges to handgun policies such as "Heller" and against the city of New Orleans for disarming citizens in the aftermath of Katrina and against DC for making the requirements to onerous for handgun carry permits. They do a good job of leveraging membership and money. That said, write your legislators, be active and loud and be prepared to lay it all on the line when/if they come for your weapons. Sent from my iPhone using Tapatalk