VEHICLES, CAMPERS, and BOATS > Build Threads
NEED HELP
Bigdave_185:
2007 2500 Silverado rear axle bearings. Need a phone call.
I am not positive the hub was assembled correctly.
Raising boys into RealMen!!
Nate:
wait one, ill get somebody to answer for you.
Wilbur:
Hey Dave- will any of these diagrams help?
http://www.demandaam.com/technical-support/gm-part-diagrams
Sorry I don't know enough to help specifically....I know plenty here do so I'm sure someone will help but this might be a start...
Bigdave_185:
What axle does it have. I think 14 bolt right?
Raising boys into RealMen!!
Bigdave_185:
ok, looking at a the 11.5 aam, it appears in the lower left diagram that the stack up goes as follows, the bearing, the race, the c clip (it was a bitch to remove) then the next race goes in and the bearing then seal follows i will proceed to that point! ::)
Navigation
[0] Message Index
[#] Next page
Go to full version