0 Members and 1 Guest are viewing this topic.
Doesn't the camera flash at you and say "no SD card"??
"I drove down the lane and wrecked four trees just because i could. Then I came up to my gate. A gate that is probably 8-9 feet wide. The tracks on this thing are 12 feet wide. So, screw it, I just plowed over the west side and crushed it flat. Made a pleasing sound."Well, now one should be able to get a trailer down the lane without too much pucker factor! That WAS a nice fence post you took out with the tracks if I remember correctly! Well, now you can build a fancy wrought iron gate to replace it!
Thre is usually a setting in the menu that asks if you want to allow shooting without card. Change that to "no". Problem solved.
Quote from: rpar86 on June 20, 2017, 01:39:54 AMDoesn't the camera flash at you and say "no SD card"??Yep sure does!My son noticed it doing that late in the day!
I think the cab either swung into an obstacle bending this up, or possibly with the additional length of the bucket coupler, the bucket curl may have gotten into the cab..?Anyway, I think this is a scar. Worthy of a fresh coat of paint, but not of straightening.What say ye? Paint and call it a day, or lavish on the body work, cracking the lower glass and losing a week digging time in the process?
Upgrade the Hydrolics?
I just don't want to wind up missing a digit or limb. I can sometimes get in a hurry to get results.
Probably should start using the proper equipment for the challenge, I mean job to do...
Don, you now have just about every piece of ground clearing equipment you need. Choose wisely and just maybe the stuff will hold up a bit longer. Now that you can widen the entrance road, buy gravel delivered. Much cheaper than trying to maintain a dump truck.
Quote from: Bob/OlallaWa on June 24, 2017, 11:08:43 AMDon, you now have just about every piece of ground clearing equipment you need. Choose wisely and just maybe the stuff will hold up a bit longer. Now that you can widen the entrance road, buy gravel delivered. Much cheaper than trying to maintain a dump truck.*cough*D6*cough*
Don, instead of trying to straighten that metal why not cut it out. Have some shop fab up a straight section & weld back in place? I mean, Ken mig welds outside so it can be done however unadviseable it might be to do so......
HEY BIG D, IF YOU GIVE ME YOUR SERIAL NUMBER I CAN ORDER YOU THE CHANNEL TO REPLACE THE DENTED ONE.